Teledyne Sierra M6-2 User Manual page 476

Teledyne LeCroy
Set Speed = LINK_SPEED_1_5G
Set Speed = LINK_SPEED_3G
Set Speed = LINK_SPEED_6G
DevSlp
Exit_DevSlp
Send_Phy_Capability
Send_Train_TrainDone
Delay (#)
Power_Expansion_On
Power_Expansion_Off
Exit (
474
)
ExitCode
Sierra Trainer Generation Commands
Generator will change speed to 1.5G (if
MultiSpeed is enabled)
This settings is not applied
Advanced Connect is set.
Generator will change speed to 3G (if
MultiSpeed is enabled).
This settings is not applied
Advanced Connect is set.
Generator will change speed to 6G (if
MultiSpeed is enabled).
This settings is not applied
Advanced Connect is set.
Makes the device sleep signal high. Trainer
doesn't go to Electric idle mode
automatically after Devslp command. We
can force trainer to go to DC Idle mode
using the "disconnect " command after
Devslp command. This command works
when Generation mode is
GEN_MODE_SAS_INITIATOR or
GEN_MODE_SATA_HOST
Makes Device sleep signal low (comes out
of device sleep mode). This command
works when Generation mode is
GEN_MODE_SAS_INITIATOR or
GEN_MODE_SATA_HOST
Generator will send PHY Capability Bits.
(this command is used in SNW3).
Generator will send Train/Train Done
Patterns.
(This Command is used in Train Windows).
Generator will wait until # ns before
executing next command.
Switch on power expansion card.
Switch off power expansion card
Call this command in any branch of the
Trainer program to stop execution. After
exit, the Port Status dialog displays the exit
code.
Note: The Trainer GUI has LED indicators:
Green is for pass.
Red is for fail.
No color is for unknown or for user to
review.
Sierra M6‐2 SAS/SATA Protocol Analyzer User Manual
.
when
when
when