Removing Expansion Cards - Teledyne Sierra M6-2 User Manual

Expandability
It is shipped with the following three cables:
1.9.5

Removing Expansion Cards

You can remove both expansion cards using two tools:
To remove an expansion card, follow these steps:
1. Unplug the system from AC power and turn the system so the expansion port is
Sierra M6‐2 SAS/SATA Protocol Analyzer User Manual
Standard 4‐pin power connector (ground, 5v, 12v only): This is a direct replace‐

ment for the existing Power Expansion Card cable.
SATA 15‐pin power segment connector: This plugs in to the power segment of

the standard SATA connector, allowing to control and monitor its power and
DevSlp.
DevSlp cable: This cable is used to monitor DevSlp levels when the Device is con‐

nected directly to the Host. It is up to the user to supply a copy of the DevSlp sig‐
nal coming from the Host to connect to the DevSlp wire of this cable, as well as
to connect the adequate ground wire of this cable.
Standard (flat blade) 3/16" screwdriver

Teledyne LeCroy Extraction Tool (part number 230‐0160‐00)

facing you. Note the two retaining screws and the holes for the extraction tool that
are located on the panel of the expansion card.
Teledyne LeCroy
33