Download Print this page

Ducati Monster S4RS Service Manual page 211

Hide thumbs Also See for Monster S4RS:

Advertisement

sezione / section
G 7
8
9
10
11
12
13
8
A
8
18
Monster S4RS - M.Y. 2006 - edizione/edition 00
Ruote - Sospensioni - Freni
Wheels - Suspensions - Brakes
Smontaggio e revisione
tirante ammortizzatore
19
Svitare e rimuovere la vite
superiore (1), il tappo (20), la vite
inferiore (17) e la boccola (18).
Smontare il tirante completo (11).
Il tirante (11) è composto da un'asta
centrale, da due dadi (10) e (12) e da
due snodi sferici (9) e (13). Sugli snodi,
in corrispondenza del foro di
fulcraggio, lavorano due bussole (8).
Dopo aver rimosso le bussole (8)
verificare, ruotando a mano l'anello
interno, il gioco dello snodo sferico:
in caso di gioco eccessivo sostituirlo.
Durante le operazioni di
ricomposizione fare attenzione al
dado (12) con filettatura sinistrorsa,
riconoscibile dalla segnatura (A): va
montato in corrispondenza della parte
segnata (A) dell'asta centrale (11).
L'interasse tra gli snodi deve essere
261 mm.
Modificando questa quota si modifica
l'assetto della moto.
Serrare i dadi (10) e (12) sull'asta
centrale (11) alla coppia prescritta
(Sez. C 3).
8
17
1
Disassembly and
overhaul of the shock
absorber tie-rod
Unscrew and remove the upper
bolt (1), the cap (20), the lower
bolt (17) and the bush (18).
Remove the tie-rod assembly (11).
The tie–rod assembly (11)
is comprised of a central rod,
two nuts (10) and (12) and two ball
joints (9) and (13). Two mounting
collars (8) are located at the sides
of each ball joint.
After removing the collars (8), check
the amount of play in the ball joint by
turning the internal ring by hand:
change the ball joint if it has
excessive play.
During reassembly, note that the
nut (12) marked (A) has a left
hand thread: on reassembly, note
that this nut is to be fitted to the end
of the rod (11) also marked (A).
The centre-to-centre distance
between the ball joints should be
261 mm.
Altering this distance will affect the
rear ride height of the motorcycle.
Tighten the nuts (10) and (12) on the
central rod (11) to the specified
torque (Sect. C 3).
9
10
11
12
A
13
A
B
C
D
E
F
G
H
L
M
N
P
39

Hide quick links:

Advertisement

loading