Download Print this page

Ducati Monster S4RS Service Manual page 409

Hide thumbs Also See for Monster S4RS:

Advertisement

sezione / section
N 6.2
13
12
11
Monster S4RS - M.Y. 2006 - edizione/edition 00
Motore
Engine
Ricomposizione
coperchio frizione
Se è stata sostituita, installare la
boccola (10) all'interno della cava nel
coperchio frizione utilizzando un
tampone adatto o una pressa per
spingerla in battuta.
In caso di sostituzione dell'anello di
tenuta (11), rimontare il particolare
nuovo all'interno del coperchio
frizione disponendolo con il lato
sprovvisto di molla rivolto verso il
seeger (13).
Verificare prima del montaggio che gli
6
spigoli della cava del seeger siano
esenti da bave che potrebbero
danneggiare l'anello di tenuta.
Inserire poi il rasamento (12) e il
seeger (13).
Importante
Affinché l'anello di tenuta (11)
lavori correttamente, deve risultare un
gioco di montaggio tale da permettere
la rotazione del seeger (13).
Se è stato rimosso, installare l'anello
di tenuta (6) nuovo sul coperchio
frizione, posizionato con il lato
provvisto di molla rivolto verso
l'interno (vedi figura), e lubrificare i
labbri di tenuta con olio motore.
Montare il tappo (3) e la
guarnizione (7). Montare il sensore (9)
e la guarnizione (8). Montare il
tappo (16) e la guarnizione (17).
Reassembly of the RH
crankcase cover
If the bush has been renewed, seat
the new bush (10) in the crankcase
cover using a suitable drift or a press.
If the oil seal (11) needs to be
renewed, fit the new seal into the
crankcase cover, positioning it so the
side without a spring is facing the
circlip (13).
Before fitting, check that the edges
of the circlip groove show no sign of
burrs which might otherwise damage
the seal.
Then fit the shim (12) and the
circlip (13).
Important
In order for the oil seal (11) to
function correctly, it must have an
assembly clearance that allows the
circlip (13) to rotate.
If it has been removed, install the
new oil seal (6) in the crankcase
cover, with the spring side facing
inwards (see figure), and lubricate the
seal lips with engine oil.
Fit the plug (3) and the seal (7).
Fit sensor (9) and gasket (8). Fit the
plug (16) and the seal (17).
A
B
C
D
E
F
G
H
L
M
N
P
109

Hide quick links:

Advertisement

loading