Fi/Ign/Pump Relay; Ecm - Honda NSA700A DN-1 2009 Service Manual

FUEL SYSTEM (PGM-FI)
Installation is in the reverse order o f rem oval.
Install tne bank
angle sensor with
" " TORQUE: 0.5 N-m (0.05 kgf-m, 0.4 Ibf-ft)
its UP mark
facing up.

FI/IGN/PUMP RELAY

INSPECTION
Remove the seat (page 3-4).
Open the fuse/relay box and rem ove the
PUMP relay.
Connect an ohm m e ter to the FI/IGN/PUMP relay
connector term inals.
Connect a 12 V battery to the fo llo w in g FI/IGN/
PUMP relay connector term inals as show n.
There should be co n tinuity o nly when the 12 V bat­
te ry is connected.
If there is no co n tin u ity when the 12 V battery is
connected, replace the FI/IGN/PUMP relay.

ECM

REMOVAL/INSTALLATION
Remove the center cow l (page 3-6).
Disconnect the ECM 33P connectors.
Remove the rubber band and the ECM.
Installation is in the reverse order o f rem oval.
6-68
FI/IGN/
FI/IGN/PUMP RELAY
33P CONNECTORS
RUBBER BAND