Ecm - Honda CBF600SA Service Manual

Manuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keys.

ECM

REMOVAL/INSTALLATION
Remove the right side cover (page 2-5).
Turn the ignition switch to "OFF".
Remove the screw.
Pull out the ECM from the stay.
Disconnect the 33P (Black and Light gray) connec-
tors from the ECM.
Installation is in the reverse order of removal.
After replacing the ECM, register the new transpon-
der keys (page 21-6).
ECM POWER/GROUND LINE
INSPECTION
ENGINE DOES NOT START (No DTC and MIL
blinking)
1. ECM Power Input Voltage Inspection
• Before starting the inspection, check for loose
or poor contact on the ECM 33P connectors
and recheck the MIL blinking.
Disconnect the ECM 33P (Black) connector.
Turn the ignition switch ON and engine stop
switch "
Measure the voltage at the ECM 33P (Black) con-
nector terminal and ground.
TOOL:
Test probe
CONNECTION: A4 (+) – Ground (–)
Is there battery voltage?
YES
NO
email: info@motomatrix.co.uk
".
07ZAJ-RDJA110
– GO TO STEP 2.
– GO TO STEP 3.
FUEL SYSTEM (PGM-FI)
33P (Black) CONNECTOR
33P (Light gray) CONNECTOR
33P (Black) CONNECTOR
(Wire side/female terminal)
SCREW
ECM
A4 TERMINAL
5-97