Open Shortest Path First (Ospf) Commands; Router Ospf; Enable (Ospf); Network Area (Ospf) - NETGEAR ProSafe M7100-24X User Manual

Term Definition
Packets with expired
The number of packets received with TTL of 0 or 1 that might otherwise have been
TTL
relayed.
Packets that
The number of packets ignored by the relay agent because they match a discard
matched a discard
relay entry.
entry

Open Shortest Path First (OSPF) Commands

This section describes the commands you use to view and configure OSPF, which is a
link-state routing protocol that you use to route traffic within a network.

router ospf

Use this command to enter Router OSPF mode.
Format
router ospf
Mode
Global Config

enable (OSPF)

This command resets the default administrative mode of OSPF in the router (active).
Default
enabled
Format
enable
Mode
Router OSPF Config
no enable (OSPF)
This command sets the administrative mode of OSPF in the router to inactive.
Format
no enable
Mode
Router OSPF Config

network area (OSPF)

Use this command to enable OSPFv2 on an interface and set its area ID if the IP address of
an interface is covered by this network command.
Default
disabled
Format
network <ip-address> <wildcard-mask> area <area-id>
Mode
Router OSPF Config
ProSafe Managed Switch
Routing Commands
259