Show Ip Vrrp Interface Brief; Open Shortest Path First (Ospf) Commands; Router Ospf; Enable (Ospf) - NETGEAR ProSafe FSM7326P Cli Reference Manual

Command Line Interface Reference for the ProSafe 7300S Series Layer-3 Stackable Switches,
Administrative
Mode
State

14.5.12 show ip vrrp interface brief

This command displays information about each virtual router configured on the 7300S
Series Stackable Switch. This command takes no options. It displays information about
each virtual router.
Format
Modes
Interface
VRID
IP Address
Mode
State

14.6 Open Shortest Path First (OSPF) Commands

This section describes the commands you use to view and configure OSPF, which is a
link-state routing protocol that you use to route traffic within a network.

14.6.1 router ospf

Use this command to enter Router OSPF mode.
Format
Mode

14.6.2 enable (OSPF)

This command resets the default administrative mode of OSPF in the router (active).
Default
Format
Mode
Routing Commands
Represents the status (Enable or Disable) of the specific
router.
Represents the state (Master/backup) of the virtual router.
show ip vrrp interface brief
Privileged EXEC
User EXEC
Valid slot and port number separated by forward slashes.
Represents the router ID of the virtual router.
The virtual router IP address.
Represents whether the virtual router is enabled or disabled.
Represents the state (Master/backup) of the virtual router.
router ospf
Global Config
enabled
enable
Router OSPF Config
v1.0, March 2006
14-31