Set Gmrp Interfacemode; Show Gmrp Configuration - NETGEAR ProSafe M7100-24X User Manual

set gmrp interfacemode

This command enables GARP Multicast Registration Protocol on a single interface (Interface
Config mode) or all interfaces (Global Config mode). If an interface which has GARP enabled
is enabled for routing or is enlisted as a member of a port-channel (LAG), GARP functionality
is disabled on that interface. GARP functionality is subsequently re-enabled if routing is
disabled and port-channel (LAG) membership is removed from an interface that has GARP
enabled.
Default
disabled
Format
set gmrp interfacemode
Mode
• Interface Config
• Global Config
no set gmrp interfacemode
This command disables GARP Multicast Registration Protocol on a single interface or all
interfaces. If an interface which has GARP enabled is enabled for routing or is enlisted as a
member of a port-channel (LAG), GARP functionality is disabled. GARP functionality is
subsequently re-enabled if routing is disabled and port-channel (LAG) membership is
removed from an interface that has GARP enabled.
Format
no set gmrp interfacemode
Mode
• Interface Config
• Global Config

show gmrp configuration

This command displays Generic Attributes Registration Protocol (GARP) information for one
or all interfaces.
Format
show gmrp configuration {<unit/slot/port> | all}
Mode
• Privileged EXEC
• User EXEC
Term Definition
Interface
The unit/slot/port of the interface that this row in the table describes.
Join Timer
The interval between the transmission of GARP PDUs registering (or re-registering)
membership for an attribute. Current attributes are a VLAN or multicast group. There is
an instance of this timer on a per-port, per-GARP participant basis. Permissible values
are 10 to 100 centiseconds (0.1 to 1.0 seconds). The factory default is 20 centiseconds
(0.2 seconds). The finest granularity of specification is 1 centisecond (0.01 seconds).
ProSafe Managed Switch
Switching Commands
75