Set Mld Querier Timer Expiry; Set Mld Querier Election Participate; No Set Mld Querier Timer Expiry; No Set Mld Querier Election Participate - NETGEAR ProSafe M7100-24X User Manual

set mld querier timer expiry

Use this command to set the MLD Querier timer expiration period. This is the time period that
the switch remains in Non-Querier mode once it discovers that there is a Multicast Querier in
the network.
Default 60 seconds
Format
set mld querier timer expiry <60-300>
Mode Global Config

no set mld querier timer expiry

Use this command to set the MLD Querier timer expiration period to its default value.
Format
no set mld querier timer expiry
Mode Global Config

set mld querier election participate

Use this command to enable the Snooping Querier to participate in the Querier Election
process when it discovers the presence of another Querier in the VLAN. When this mode is
enabled, if the Snooping Querier finds that the other Querier's source address is better (less)
than the Snooping Querier's address, it stops sending periodic queries. If the Snooping
Querier wins the election, then it will continue sending periodic queries.
Default disabled
Format
set mld querier election participate
Mode VLAN Config

no set mld querier election participate

Use this command to set the snooping querier not to participate in querier election, but go
into a non-querier mode as soon as it discovers the presence of another querier in the same
VLAN.
Format
no set mld querier election participate
Mode VLAN Config
ProSafe Managed Switch
Switching Commands
166