Dot1X Max-Req; Dot1X Max-Users - NETGEAR ProSafe M7100-24X User Manual

devices' MAC address as an identifier. This requires that the known and allowable MAC
address and corresponding access rights be pre-populated in the authentication server. MAB
works only when the port control mode of the port is MAC-based.
Format
dot1x mac-auth-bypass
Mode
Interface Config
no dot1x mac-auth-bypass
This command disables MAB for 802.1x-unaware clients.
Format
no dot1x mac-auth-bypass
Mode
Interface Config

dot1x max-req

This command sets the maximum number of times the authenticator state machine on this
port will transmit an EAPOL EAP Request/Identity frame before timing out the supplicant. The
<count> value must be in the range 1 - 10.
Default
2
Format
dot1x max-req <count>
Mode
Interface Config
no dot1x max-req
This command sets the maximum number of times the authenticator state machine on this
port will transmit an EAPOL EAP Request/Identity frame before timing out the supplicant.
Format
no dot1x max-req
Mode
Interface Config

dot1x max-users

Use this command to set the maximum number of clients supported on the port when
MAC-based dot1x authentication is enabled on the port. The maximum users supported per
port is dependent on the product. The <count> value is in the range 1 - 16.
Default
16
Format
dot1x max-users <count>
Mode
Interface Config
ProSafe Managed Switch
Switching Commands
78