Dhcp And Bootp Relay Commands; Show Ip Vrrp Interface Brief; Bootpdhcprelay Cidoptmode - NETGEAR ProSafe M7100-24X User Manual

10.10.10.1/255.255.255.0

show ip vrrp interface brief

This command displays information about each virtual router configured on the switch. This
command takes no options. It displays information about each virtual router.
Format
show ip vrrp interface brief
Modes
• Privileged EXEC
• User EXEC
Term Definition
Interface
Valid slot and port number separated by forward slashes.
VRID
The router ID of the virtual router.
IP Address
The virtual router IP address.
Mode
Indicates whether the virtual router is enabled or disabled.
State
The state (Master/backup) of the virtual router.

DHCP and BOOTP Relay Commands

This section describes the commands you use to configure BootP/DHCP Relay on the
switch. A DHCP relay agent operates at Layer 3 and forwards DHCP requests and replies
between clients and servers when they are not on the same physical subnet.

bootpdhcprelay cidoptmode

This command enables the circuit ID option mode for BootP/DHCP Relay on the system.
Default
disabled
Format
bootpdhcprelay cidoptmode
Mode
Global Config
no bootpdhcprelay cidoptmode
This command disables the circuit ID option mode for BootP/DHCP Relay on the system.
Format
no bootpdhcprelay cidoptmode
Mode
Global Config
ProSafe Managed Switch
down 10
Routing Commands
253