Ip Vrrp Track Ip Route; Ip Vrrp <Vrid> Accept-Mode - NETGEAR ProSafe M7100-24X User Manual

no ip vrrp track interface
Use this command to remove the interface from the tracked list or to restore the priority
decrement to its default.
Format
no ip vrrp <vrid> track interface <unit/slot/port> [decrement]
Mode
Interface Config

ip vrrp track ip route

Use this command to track the route reachability. When the tracked route is deleted, the
priority of the VRRP router will be decremented by the value specified in the <priority>
argument. When the tracked route is added, the priority will be incremented by the same.
A VRRP configured interface can track more than one route. When a tracked route goes
down, then the priority of the router will be decreased by 10 (the default priority decrement)
for each downed route. By default no routes are tracked. If you specify just the route to be
tracked, without giving the optional priority, then the default priority will be set. The default
priority decrement is 10. The default priority decrement is changed using the <priority>
argument.
Default
priority: 10
Format
ip vrrp <vrid> track ip route <ip-address/prefix-length> [decrement
<priority>]
Mode
Interface Config
no ip vrrp track ip route
Use this command to remove the route from the tracked list or to restore the priority
decrement to its default. When removing a tracked IP route from the tracked list, the priority
should be incremented by the decrement value if the route is not reachable.
Format
no ip vrrp <vrid> track ip route <ip-address/prefix-length>
[decrement]
Mode
Interface Config
ip vrrp <vrid> accept-mode
This command is used to allow a router to respond to ICMP Echo Requests sent to an
address on a VRRP virtual router. VRRP supports responding to pings, but does not allow
the VRRP Master to accept other types of packets. A new configuration option controls
whether the router responds to Echo Requests sent to a VRRP IP address.
The VRRP Master responds to both fragmented and un-fragmented ICMP Echo Request
packets. The VRRP Master responds to Echo Requests sent to the virtual router's primary
address or any of its secondary addresses.
ProSafe Managed Switch
Routing Commands
249