Ip Local-Proxy-Arp; Ip Proxy-Arp - NETGEAR ProSafe M7100-24X User Manual

arp
This command creates an ARP entry. The value for <ipaddress> is the IP address of a
device on a subnet attached to an existing routing interface. <macaddr> is a unicast MAC
address for that device.
The format of the MAC address is 6 two-digit hexadecimal numbers that are separated by
colons, for example 00:06:29:32:81:40.
Format
arp <ipaddress> <macaddr>
Mode
Global Config
no arp
This command deletes an ARP entry. The value for <arpentry> is the IP address of the
interface. The value for <ipaddress> is the IP address of a device on a subnet attached to
an existing routing interface. <macaddr> is a unicast MAC address for that device.
Format
no arp <ipaddress> <macaddr>
Mode
Global Config

ip local-proxy-arp

This command enables local-proxy-arp on interface or range of interfaces. The switch only
responds if all next hops in its route to the destination are through interfaces other than the
interface that received the ARP request. Enabling local proxy ARP removes this restriction..
Default
disabled
Format
ip local-proxy-arp
Mode
Interface Config
no ip local-proxy-arp
This command disables local-proxy-arp on the interface or a range of interfaces.
Format
no ip local-proxy-arp
Mode
Interface Config

ip proxy-arp

This command enables proxy ARP on a router interface. Without proxy ARP, a device only
responds to an ARP request if the target IP address is an address configured on the interface
where the ARP request arrived. With proxy ARP, the device may also respond if the target IP
ProSafe Managed Switch
Routing Commands
218