Ip Route Distance; Ip Netdirbcast - NETGEAR ProSafe M7100-24X User Manual

no ip route default
This command deletes all configured default routes. If the optional <nexthopip> parameter
is designated, the specific next hop is deleted from the configured default route and if the
optional preference value is designated, the preference of the configured default route is
reset to its default.
Format
no ip route default [{<nexthopip> | <preference>}]
Mode
Global Config

ip route distance

This command sets the default distance (preference) for static routes. Lower route distance
values are preferred when determining the best route. The ip route and ip route
default commands allow you to optionally set the distance (preference) of an individual
static route. The default distance is used when no distance is specified in these commands.
Changing the default distance does not update the distance of existing static routes, even if
they were assigned the original default distance. The new default distance will only be
applied to static routes created after invoking the ip route distance command.
Default
1
Format
ip route distance <1-255>
Mode
Global Config
no ip route distance
This command sets the default static route preference value in the router. Lower route
preference values are preferred when determining the best route.
Format
no ip route distance
Mode
Global Config

ip netdirbcast

This command enables the forwarding of network-directed broadcasts. When enabled,
network directed broadcasts are forwarded. When disabled they are dropped.
Default
disabled
Format
ip netdirbcast
Mode
Interface Config
ProSafe Managed Switch
Routing Commands
228