Clear Ip Arp Inspection Statistics; Show Ip Arp Inspection Interfaces - NETGEAR ProSafe M7100-24X User Manual

VLAN DHCP ACL
Drops Drops
----- -------- --------- ----------- --------- ---------- ----------- ---------
10 11 1
20 1 0

clear ip arp inspection statistics

Use this command to reset the statistics for Dynamic ARP Inspection on all VLANs.
Default
none
Format
clear ip arp inspection statistics
Mode
Privileged EXEC

show ip arp inspection interfaces

Use this command to display the Dynamic ARP Inspection configuration on all the
DAI-enabled interfaces. An interface is said to be enabled for DAI if at least one VLAN, that
the interface is a member of, is enabled for DAI. Given a unit/slot/port interface argument, the
command displays the values for that interface whether the interface is enabled for DAI or
not.
Format
show ip arp inspection interfaces [unit/slot/port]
Mode
• Privileged EXEC
• User EXEC
Term Definition
Interface
The interface ID for each displayed row.
Trust State
Whether the interface is trusted or untrusted for DAI.
Rate Limit
The configured rate limit value in packets per second.
Burst Interval
The configured burst interval value in seconds.
Example: The following shows example CLI display output for the command.
(Switch) #show ip arp inspection interfaces
Interface Trust State
--------------- -----------
0/1
0/2
ProSafe Managed Switch
DHCP ACL
Permits Permits
65
8
Rate Limit
(pps)
----------
Untrusted
Untrusted
Switching Commands
Bad Src Bad Dest
MAC
25 1
2 0
Burst Interval
(seconds)
---------------
15 1
10 10
145
Invalid
MAC IP
1 0
1 1