Storm-Control Broadcast Rate - NETGEAR ProSafe M7100-24X User Manual

interface increases beyond the configured threshold, the traffic is dropped. Therefore, the
rate of broadcast traffic is limited to the configured threshold.
Default
5
Format
storm-control broadcast level <0-100>
Mode
Interface Config
no storm-control broadcast level
This command sets the broadcast storm recovery threshold to the default value for an
interface and disables broadcast storm recovery.
Format
no storm-control broadcast level
Mode
Interface Config

storm-control broadcast rate

Use this command to configure the broadcast storm recovery threshold for an interface in
packets per second. If the mode is enabled, broadcast storm recovery is active, and if the
rate of L2 broadcast traffic ingressing on an interface increases beyond the configured
threshold, the traffic is dropped. Therefore, the rate of broadcast traffic is limited to the
configured threshold.
Default
0
Format
storm-control broadcast rate <0-14880000>
Mode
Interface Config
no storm-control broadcast rate
This command sets the broadcast storm recovery threshold to the default value for an
interface and disables broadcast storm recovery.
Format
no storm-control broadcast rate
Mode
Interface Config
storm-control broadcast (Global)
This command enables broadcast storm recovery mode for all interfaces. If the mode is
enabled, broadcast storm recovery is active, and if the rate of L2 broadcast traffic ingressing
on an interface increases beyond the configured threshold, the traffic will be dropped.
Therefore, the rate of broadcast traffic will be limited to the configured threshold.
Default
disabled
ProSafe Managed Switch
Switching Commands
94