NETGEAR ProSafe M7100-24X User Manual page 471

VLAN, then the ACL rule is applied immediately. If a time range withspecified name exists
and the MAC ACL containing this ACL rule is applied to aninterface or bound to a VLAN, then
the ACL rule is applied when the time-range withspecified name becomes active. The ACL
rule is removed when the time-range withspecified name becomes inactive.
Ethertype Keyword
appletalk
arp
ibmsna
ipv4
ipv6
ipx
mplsmcast
mplsucast
netbios
novell
pppoe
rarp
The vlan and cos parameters refer to the VLAN identifier and 802.1p user priority fields,
respectively, of the VLAN tag. For packets containing a double VLAN tag, this is the first (or
outer) tag.
The assign-queue parameter allows specification of a particular hardware queue for handling
traffic that matches this rule. The allowed <queue-id> value is 0-(n-1), where n is the
number of user configurable queues available for the hardware platform. The
assign-queue parameter is valid only for a permit rule.
Note: The special command form {deny | permit} any any is used to match
all Ethernet layer 2 packets, and is the equivalent of the IP access
list "match every" rule.
Format
{deny|permit} {<srcmac> | any} {<dstmac> | any} [<ethertypekey> |
<0x0600-0xFFFF>] [vlan {eq <0-4095>}] [cos <0-7>] [[log] [time-range
<time-range-name>][assign-queue <queue-id>]] [{mirror | redirect}
<unit/slot/port>]
Mode
Mac-Access-List Config
ProSafe Managed Switch
Corresponding Value
0x809B
0x0806
0x80D5
0x0800
0x86DD
0x8037
0x8848
0x8847
0x8191
0x8137, 0x8138
0x8863, 0x8864
0x8035
Quality of Service (QoS) Commands
471