Ip Vrrp Timers Advertise; Ip Vrrp Track Interface - NETGEAR ProSafe M7100-24X User Manual

ip vrrp timers advertise

This command sets the frequency, in seconds, that an interface on the specified virtual router
sends a virtual router advertisement.
Default
1
Format
ip vrrp <vrid> timers advertise <1-255>
Mode
Interface Config
no ip vrrp timers advertise
This command sets the default virtual router advertisement value for an interface.
Format
no ip vrrp <vrid> timers advertise
Mode
Interface Config

ip vrrp track interface

Use this command to alter the priority of the VRRP router based on the availability of its
interfaces. This command is useful for tracking interfaces that are not configured for VRRP.
Only IP interfaces are tracked. A tracked interface is up if the IP on that interface is up.
Otherwise, the tracked interface is down.
When the tracked interface is down or the interface has been removed from the router, the
priority of the VRRP router will be decremented by the value specified in the <priority>
argument. When the interface is up for IP protocol, the priority will be incremented by the
<priority> value.
A VRRP configured interface can track more than one interface. When a tracked interface
goes down, then the priority of the router will be decreased by 10 (the default priority
decrement) for each downed interface. The default priority decrement is changed using the
<priority> argument. The default priority of the virtual router is 100, and the default
decrement priority is 10. By default, no interfaces are tracked. If you specify just the interface
to be tracked, without giving the optional priority, then the default priority will be set. The
default priority decrement is 10.
Default
priority: 10
Format
ip vrrp <vrid> track interface <unit/slot/port> [decrement
<priority>]
Mode
Interface Config
ProSafe Managed Switch
Routing Commands
248