Auto-Voip {Protocol-Based | Oui-Based; Auto-Voip Oui - NETGEAR ProSafe M7100-24X User Manual

Note: If voice VLAN and Auto-VoIP are enabled at the same time, then
one of them is operational. If the connected phone is LLDP-MED
capable, then voice VLAN has precedence over the Auto VoIP and
Auto VoIP is operational if the phone does not support LLDP-MED.

auto-voip {protocol-based | oui-based}

This command is used to configure auto VoIP mode. The supported modes are
protocol-based and oui-based. Protocol based auto VoIP prioritizes the voice data based on
the layer 4 port used for the voice session. OUI based auto VOIP prioritizes the phone traffic
based on the known OUI of the phone.
Format
auto-voip {protocol-based | oui-based}
Mode
• Global Config
• Interface Config
Default
oui-based
no auto-voip {protocol-based | oui-based}
This command is used to set default mode.
Format
no auto-voip {protocol-based | oui-based}
Mode
• Global Config
• Interface Config

auto-voip oui

This command is used to configure an OUI for Auto VoIP. The traffic from the configured OUI
will get the highest priority over the other traffic.
Format
auto-voip oui <oui-prefix> oui-desc <string>
Mode
Global Config
Default
A list of known OUIs is present
no auto-voip oui
This command is to delete already configured OUI.
Format
no auto-voip oui <oui-prefix>
Mode
Global Config
ProSafe Managed Switch
Quality of Service (QoS) Commands
487