Ip Mtu - NETGEAR ProSafe M7100-24X User Manual

no ip netdirbcast
This command disables the forwarding of network-directed broadcasts. When disabled,
network directed broadcasts are dropped.
Format
no ip netdirbcast
Mode
Interface Config

ip mtu

This command sets the IP Maximum Transmission Unit (MTU) on a routing interface. The IP
MTU is the size of the largest IP packet that can be transmitted on the interface without
fragmentation. The software currently does not fragment IP packets.
• Packets forwarded in hardware ignore the IP MTU.
• Packets forwarded in software are dropped if they exceed the IP MTU of the outgoing
interface.
Packets originated on the router, such as OSPF packets, may be fragmented by the IP stack.
The IP stack uses its default IP MTU and ignores the value set using the ip mtu command.
OSPF advertises the IP MTU in the Database Description packets it sends to its neighbors
during database exchange. If two OSPF neighbors advertise different IP MTUs, they will not
form an adjacency. (unless OSPF has been instructed to ignore differences in IP MTU with
the ip ospf mtu-ignore command.)
Note: The IP MTU size refers to the maximum size of the IP packet (IP
Header + IP payload). It does not include any extra bytes that may
be required for Layer-2 headers. To receive and process packets,
the Ethernet MTU (see
size of the Ethernet header.
Default
1500 bytes
Format
ip mtu <68-9198>
Mode
Interface Config
no ip mtu
This command resets the ip mtu to the default value.
Format
no ip mtu <mtu>
Mode
Interface Config
ProSafe Managed Switch
mtu on page 23) must take into account the
Routing Commands
229