Ip Vrrp Ip; Ip Vrrp Authentication - NETGEAR ProSafe M7100-24X User Manual

ip vrrp ip

This command sets the virtual router IP address value for an interface. The value for
<ipaddr> is the IP address which is to be configured on that interface for VRRP. The
parameter <vrid> is the virtual router ID which has an integer value range from 1 to 255.
You can use the optional [secondary] parameter to designate the IP address as a
secondary IP address.
Default
none
Format
ip vrrp <vrid> ip <ipaddr> [secondary]
Mode
Interface Config
no ip vrrp ip
Use this command in Interface Config mode to delete a secondary IP address value from the
interface. To delete the primary IP address, you must delete the virtual router on the interface.
Format
no ip vrrp <vrid> <ipaddress> secondary
Mode
Interface Config

ip vrrp authentication

This command sets the authorization details value for the virtual router configured on a
specified interface. The parameter {none | simple} specifies the authorization type for
virtual router configured on the specified interface. The parameter [key] is optional, it is only
required when authorization type is simple text password. The parameter <vrid> is the
virtual router ID which has an integer value ranges from 1 to 255.
Default
no authorization
Format
ip vrrp <vrid> authentication {none | simple <key>}
Mode
Interface Config
no ip vrrp authentication
This command sets the default authorization details value for the virtual router configured on
a specified interface.
Format
no ip vrrp <vrid> authentication
Mode
Interface Config
ProSafe Managed Switch
Routing Commands
246