Ip Dhcp Snooping Trust; Ip Verify Source - NETGEAR ProSafe M7100-24X User Manual

no ip dhcp snooping log-invalid
Use this command to disable the logging DHCP messages filtration by the DHCP Snooping
application.
Format
no ip dhcp snooping log-invalid
Mode
Interface Config

ip dhcp snooping trust

Use this command to configure the port as trusted.
Default
disabled
Format
ip dhcp snooping trust
Mode
Interface Config
no ip dhcp snooping trust
Use this command to configure the port as untrusted.
Format
no ip dhcp snooping trust
Mode
Interface Config

ip verify source

Use this command to configure the IPSG source ID attribute to filter the data traffic in the
hardware. Source ID is the combination of IP address and MAC address. Normal command
allows data traffic filtration based on the IP address. With the "port-security" option, the data
traffic will be filtered based on the IP and MAC addresses.
Default
the source ID is the IP address
Format
ip verify source {port-security}
Mode
Interface Config
no ip verify source
Use this command to disable the IPSG configuration in the hardware. You cannot disable
port-security alone if it is configured.
Format
no ip verify source
Mode
Interface Config
ProSafe Managed Switch
Switching Commands
134