Garp Commands; Show Interface Ethernet <Unit/Slot/Port > Switchport; Set Garp Timer Join - NETGEAR ProSafe M7100-24X User Manual

Term Definition
Private -vlan
Displays information about the configured private VLANs
type
Displays only private VLAN ID and its type.
Primary
Displays primary VLAN ID
Secondary
Displays secondary VLAN ID
Type
Displays secondary VLAN type
Ports
Displays ports which are associated with a private VLAN
show interface ethernet <unit/slot/port > switchport
This command displays the private-VLAN mapping information for the switch interfaces.
Format
show interface ethernet <unit/slot/port> switchport
Mode
• Privileged EXEC
• User EXEC
Term
Private-vlan host-association
Private-vlan mapping

GARP Commands

This section describes the commands you use to configure Generic Attribute Registration
Protocol (GARP) and view GARP status. The commands in this section affect both GARP
VLAN Registration Protocol (GVRP) and Garp Multicast Registration Protocol (GMRP).
GARP is a protocol that allows client stations to register with the switch for membership in
VLANS (by using GVMP) or multicast groups (by using GVMP).

set garp timer join

This command sets the GVRP join time for one port (Interface Config mode) or all (Global
Config mode) and per GARP. Join time is the interval between the transmission of GARP
Protocol Data Units (PDUs) registering (or re-registering) membership for a VLAN or
multicast group. This command has an effect only when GVRP is enabled. The time is from
10 to 100 (centiseconds). The value 20 centiseconds is 0.2 seconds.
Default
20
Format
set garp timer join <10-100>
Mode
• Interface Config
• Global Config
ProSafe Managed Switch
Definition
Displays VLAN association for the private-VLAN host ports.
Displays VLAN mapping for the private-VLAN promiscuous ports
Switching Commands
70