Chapter 4 Routing Commands; Address Resolution Protocol (Arp) Commands - NETGEAR ProSafe M7100-24X User Manual

Routing Commands
4.
This chapter describes the routing commands available in the 7000 series CLI.
Note: Some commands described in this chapter require a license. For
more information, see
This chapter contains the following sections:
•

Address Resolution Protocol (ARP) Commands

• IP Routing Commands
• Router Discovery Protocol Commands
• Virtual LAN Routing Commands
• Virtual Router Redundancy Protocol Commands
• DHCP and BOOTP Relay Commands
• IP Helper Commands
• Open Shortest Path First (OSPF) Commands
• OSPF Graceful Restart Commands
• Routing Information Protocol (RIP) Commands
• ICMP Throttling Commands
The commands in this chapter are in three functional groups:
• Show commands display switch settings, statistics, and other information.
• Configuration commands configure features and options of the switch. For every
configuration command, there is a show command that displays the configuration setting.
• Clear commands clear some or all of the settings to factory defaults.
Address Resolution Protocol (ARP) Commands
This section describes the commands you use to configure ARP and to view ARP
information on the switch. ARP associates IP addresses with MAC addresses and stores the
information as ARP entries in the ARP cache.
Licensing and Command Support
217
4
on page 8.