Ipv6 Access-List Rename; Deny | Permit} (Ipv) - NETGEAR ProSafe M7100-24X User Manual

no ipv6 access-list
This command deletes the IPv6 ACL identified by <name> from the system.
Format
no ipv6 access-list <name>
Mode
Global Config

ipv6 access-list rename

This command changes the name of an IPv6 ACL. The <name> parameter is the name of an
existing IPv6 ACL. The <newname> parameter is a case-sensitive alphanumeric string from 1
to 31 characters uniquely identifying the IPv6 access list.
This command fails is an IPv6 ACL by the name <newname> already exists.
Format
ipv6 access-list rename <name> <newname>
Mode
Global Config
{deny | permit} (IPv6)
This command creates a new rule for the current IPv6 access list. Each rule is appended to
the list of configured rules for the list.
Note: The 'no' form of this command is not supported, since the rules
within an IPv6 ACL cannot be deleted individually. Rather, the entire
IPv6 ACL must be deleted and respecified.
Note: An implicit 'deny all' IPv6 rule always terminates the access list.
A rule may either deny or permit traffic according to the specified classification fields. At a
minimum, either the 'every' keyword or the protocol, source address, and destination
address values must be specified. The source and destination IPv6 address fields may be
specified using the keyword 'any' to indicate a match on any value in that field. The
remaining command parameters are all optional, but the most frequently used parameters
appear in the same relative order as shown in the command format.
The assign-queue parameter allows specification of a particular hardware queue for handling
traffic that matches this rule. The allowed <queue-id> value is 0-(n-1), where n is the
number of user configurable queues available for the hardware platform. The
assign-queue parameter is valid only for a permit rule.
The mirror parameter allows the traffic matching this rule to be copied to the specified
<unit/slot/port>, while the redirect parameter allows the traffic matching this rule to be
ProSafe Managed Switch
Quality of Service (QoS) Commands
481