Storm-Control Unicast Rate (Global); Show Storm-Control - NETGEAR ProSafe M7100-24X User Manual

no storm-control unicast level
This command sets the unicast storm recovery threshold to the default value and disables
unicast storm recovery for all interfaces.
Format
no storm-control unicast level
Mode
Global Config

storm-control unicast rate (Global)

Use this command to configure the unicast storm recovery threshold for all interfaces in
packets per second. If the mode is enabled, unicast storm recovery is active, and if the rate of
L2 broadcast traffic ingressing on an interface increases beyond the configured threshold,
the traffic is dropped. Therefore, the rate of unicast traffic is limited to the configured
threshold.
Default
0
Format
storm-control unicast rate <0-14880000>
Mode
Global Config
no storm-control unicast rate
This command sets the multicast storm recovery threshold to the default value for an
interface and disables multicast storm recovery.
Format
no storm-control unicast rate
Mode
Global Config

show storm-control

This command displays switch configuration information. If you do not use any of the optional
parameters, this command displays global storm control configuration parameters:
• Broadcast Storm Control Mode may be enabled or disabled. The factory default is
disabled.
• Broadcast Storm Control Level The broadcast storm control level. The factory default is
5%.
• Multicast Storm Control Mode may be enabled or disabled. The factory default is
disabled.
• Multicast Storm Control Level The multicast storm control level. The factory default is
5%.
• Unicast Storm Control Mode may be enabled or disabled. The factory default is
disabled.
• Unicast Storm Control Level The unicast storm control level. The factory default is 5%.
ProSafe Managed Switch
Switching Commands
101