Access Commands; User Account Commands; Show Loginsession - NETGEAR ProSafe M7100-24X User Manual

Access Commands

Use the commands in this section to close remote connections or to view information about
connections to the system.
disconnect
Use the disconnect command to close HTTP, HTTPS, Telnet or SSH sessions. Use all to
close all active sessions, or use <session-id> to specify the session ID to close. To view
the possible values for <session-id>, use the show loginsession command.
Format
disconnect {<session_id> | all}
Mode
Privileged EXEC

show loginsession

Use this command to display current Telnet and serial port connections to the switch.
Format
show loginsession
Mode
Privileged EXEC
Term Definition
ID
Login Session ID.
User Name
The name the user entered to log on to the system.
Connection
IP address of the remote client machine or EIA-232 for the serial port connection.
From
Idle Time
Time this session has been idle.
Session Time
Total time this session has been connected.
Session Type
Shows the type of session, which can be HTTP, HTTPS, telnet, serial, or SSH.

User Account Commands

This section describes the commands you use to add, manage, and delete system users.
The 7000 series software has two default users: admin and guest. The admin user can view
and configure system settings, and the guest user can view settings.
Note: You cannot delete the admin user. There is only one user allowed
with read/write privileges. You can configure up to five read-only
users on the system.
ProSafe Managed Switch
Management Commands
637