RADIUS Commands
This section describes the commands you use to configure the switch to use a Remote
Authentication Dial-In User Service (RADIUS) server on your network for authentication and
accounting.
authorization network radius
Use this command to enable the switch to accept VLAN assignment by the radius server.
Default
disable
Format
authorization network radius
Mode
Global Config
no authorization network radius
Use this command to disable the switch to accept VLAN assignment by the radius server.
Format
no authorization network radius
Mode
Global Config
radius accounting mode
Use this command to enable the RADIUS accounting function.
Default
disabled
Format
radius accounting mode
Mode
Global Config
no radius accounting mode
Use this command to set the RADIUS accounting function to the default value (disabled).
Format
no radius accounting mode
Mode
Global Config
radius server attribute
Use this command to specify the RADIUS client to use the NAS-IP Address attribute in the
RADIUS requests. If the specific IP address is configured while enabling this attribute, the
ProSafe Managed Switch
Management Commands
672