Ip Routing; Ip Address - NETGEAR ProSafe M7100-24X User Manual

You can view the current value for this function with the show ip brief command. The
value is labeled as "Routing Mode."
Format
no routing
Mode
Interface Config

ip routing

This command enables the IP Router Admin Mode for the master switch.
Format
ip routing
Mode
Global Config
no ip routing
This command disables the IP Router Admin Mode for the master switch.
Format
no ip routing
Mode
Global Config

ip address

This command configures an IP address on an interface. You can also use this command to
configure one or more secondary IP addresses on the interface.The value for <ipaddr> is
the IP address of the interface. The value for <subnetmask> is a 4-digit dotted-decimal
number which represents the subnet mask of the interface. The subnet mask must have
contiguous ones and be no longer than 30 bits, for example 255.255.255.0. This command
adds the label IP address in show ip interface.
Format
ip address <ipaddr> <subnetmask> [secondary]
Mode
Interface Config
Parameter Description
ipaddr The IP address of the interface.
subnetmask A four-digit dotted-decimal number that represents the subnet mask of the interface
masklen Implements RFC 3021. Using the / notation of the subnet mask, this is an integer that
indicates the length of the subnet mask. Range is 5 to 32 bits.
no ip address
This command deletes an IP address from an interface. The value for <ipaddr> is the IP
address of the interface in a.b.c.d format where the range for a, b, c, and d is 1-255. The
value for <subnetmask> is a 4-digit dotted-decimal number which represents the Subnet
ProSafe Managed Switch
Routing Commands
224