Debug Sflow Packet - NETGEAR ProSafe M7100-24X User Manual

Rip_Version: RIPv2 Packet_Type:RIP_RESPONSE
ROUTE 1): Network: 10.1.1.0 Mask: 255.255.255.0 Metric: 1
ROUTE 2): Network: 40.1.0.0 Mask: 255.255.0.0 Metric: 1
ROUTE 3): Network: 10.50.50.0 Mask: 255.255.255.0 Metric: 1
ROUTE 4): Network: 41.1.0.0 Mask: 255.255.0.0 Metric: 1
ROUTE 5): Network:42.0.0.0 Mask:255.0.0.0 Metric:1
Another 6 routes present in packet not displayed.
The following parameters are displayed in the trace message:
Parameter Definition
TX/RX
TX refers to a packet transmitted by the device. RX refers to packets received by the
device.
Intf
The interface that the packet came in or went out on. Format used is unit/slot/port
(internal interface number). Unit is always shown as 1 for interfaces on a non-stacking
device.
Src_IP
The source IP address in the IP header of the packet.
Dest_IP
The destination IP address in the IP header of the packet.
Rip_Version
RIP version used <RIPv1 or RIPv2>.
Packet_Type
Type of RIP packet. <RIP_REQUEST or RIP_RESPONSE>.
Routes
Up to 5 routes in the packet are displayed in the following format:
Network: <a.b.c.d> Mask <a.b.c.d> Next_Hop <a.b.c.d> Metric <a>
The next hop is only displayed if it is different from 0.0.0.0.
For RIPv1 packets, Mask is always 0.0.0.0.
Number of
Only the first five routes present in the packet are included in the trace. There is another
routes not
notification of the number of additional routes present in the packet that were not
printed
included in the trace.
no debug rip packet
This command disables tracing of RIP requests and responses.
Format
no debug rip packet
Mode
Privileged EXEC

debug sflow packet

Use this command to enable sFlow debug packet trace.
Default
disabled
Format
debug sflow packet
Mode
Privileged EXEC
ProSafe Managed Switch
Utility Commands
591