Ipv6 Mld Last-Member-Query-Interval; Ipv6 Mld Last-Member-Query-Count - NETGEAR ProSafe M7100-24X User Manual

no ipv6 mld query-max-response-time
This command resets the MLD query max response time for the interface to the default
value.
Format
no ipv6 mld query-max-response-time
Mode
Interface Config

ipv6 mld last-member-query-interval

Use this command to set the last member query interval for the MLD interface, which is the
value of the maximum response time parameter in the group specific queries sent out of this
interface. The range for <last-member-query-interval> is 1 to 65535 milliseconds.
Default
1000 milliseconds
Format
ipv6 mld last-member-query-interval <last-member-query-interval>
Mode
Interface Config
no ipv6 mld last-member-query-interval
Use this command to reset the <last-member-query-interval> parameter of the
interface to the default value.
Format
no ipv6 mld last-member-query-interval
Mode
Interface Config

ipv6 mld last-member-query-count

Use this command to set the number of listener-specific queries sent before the router
assumes that there are no local members on the interface. The range for
<last-member-query-count> is 1 to 20.
Default
2
Format
ipv6 mld last-member-query-count <last-member-query-count>
Mode
Interface Config
no ipv6 mld last-member-query-count
Use this command to reset the <last-member-query-count> parameter of the interface
to the default value.
Format
no ipv6 mld last-member-query-count
Mode
Interface Config
ProSafe Managed Switch
IPv6 Multicast Commands
429