Traceroute Ipv6; Clear Config; Clear Eventlog; Clear Logging Buffered - NETGEAR ProSafe M7100-24X User Manual

Hop Count = 6 Last TTL = 7 Test attempt = 19 Test Success = 18

traceroute ipv6

Use the traceroute command to discover the routes that packets actually take when
traveling to their destination through the network on a hop-by-hop basis. The
<ipv6-address|hostname> parameter must be a valid IPv6 address or hostname. The
optional <port> parameter is the UDP port used as the destination of packets sent as part
of the traceroute. This port should be an unused port on the destination system. The range
for <port> is zero (0) to 65535. The default value is 33434.
Default
port: 33434
Format
traceroute ipv6 <ipv6-address|hostname> [port <port>]
Mode
Privileged EXEC

clear config

This command resets the configuration to the factory defaults without powering off the switch.
When you issue this command, a prompt appears to confirm that the reset should proceed.
When you enter y, you automatically reset the current configuration on the switch to the
default values. It does not reset the switch.
Format
clear config
Mode
Privileged EXEC

clear eventlog

This command clears all event messages maintained in the switch.
Format
clear eventlog
Mode
Privileged EXEC

clear mac-addr-table

This command clears the dynamically learned MAC addresses of the switch.
Format
clear mac-addr-table
Mode
Privileged EXEC

clear logging buffered

This command clears the messages maintained in the system log.
Format
clear logging buffered
Mode
Privileged EXEC
ProSafe Managed Switch
Utility Commands
542