Routing Information Protocol (Rip) Commands; Router Rip; Enable (Rip) - NETGEAR ProSafe M7100-24X User Manual

Any change in the dampening configuration resets the current
penalty, reuse time, and suppressed state to their default values,
meaning 0, 0, and FALSE respectively.
The following shows example CLI display output for the command.
(netgear switch)# show interface dampening
Interface 0/2
Flaps Penalty Supp
0 0 FALSE
Interface 0/3
Flaps Penalty Supp
6 1865 TRUE

Routing Information Protocol (RIP) Commands

This section describes the commands you use to view and configure RIP, which is a
distance-vector routing protocol that you use to route traffic within a small network.

router rip

Use this command to enter Router RIP mode.
Format
router rip
Mode
Global Config

enable (RIP)

This command resets the default administrative mode of RIP in the router (active).
Default
enabled
Format
enable
Mode
Router RIP Config
no enable (RIP)
This command sets the administrative mode of RIP in the router to inactive.
Format
no enable
Mode
Router RIP Config
ProSafe Managed Switch
ReuseTm HalfL ReuseV
0 5 1000
ReuseTm HalfL ReuseV
18 20 1000
Routing Commands
307
SuppV MaxSTm MaxP
2000 20 16000
SuppV MaxSTm MaxP
2001 30 2828
Restart
0
Restart
1500