Snmptrap Ipaddr; Snmptrap Mode; Snmp Trap Link-Status - NETGEAR ProSafe M7100-24X User Manual

snmptrap ipaddr

Use this command to assign an IP address to a specified community name. The maximum
length of name is 16 case-sensitive alphanumeric characters.
Note: IP addresses in the SNMP trap receiver table must be unique. If you
make multiple entries using the same IP address, the first entry is
retained and processed. All duplicate entries are ignored.
Format
snmptrap ipaddr <name> <ipaddrold> <ipaddrnew | hostnamenew>
Mode
Global Config

snmptrap mode

Use this command to activate or deactivate an SNMP trap. Enabled trap receivers are active
(able to receive traps). Disabled trap receivers are inactive (not able to receive traps).
Format
snmptrap mode <name> { <ipaddr | hostname> |<ip6addr |hostname>}
Mode
Global Config
no snmptrap mode
Use this command to deactivate an SNMP trap. Disabled trap receivers are unable to receive
traps.
Format
no snmptrap mode <name> { <ipaddr | hostname> |<ip6addr |hostname>}
Mode
Global Config

snmp trap link-status

Use this command to enable link status traps by interface.
Note: This command is valid only when the Link Up/Down Flag is enabled.
For more information, see
page 665.
Format
snmp trap link-status
Mode
Interface Config
ProSafe Managed Switch
snmp-server enable traps linkmode
Management Commands
668
on