Show Snmptrap - NETGEAR ProSafe M7100-24X User Manual

The SNMP agent of the switch complies with SNMP Versions 1, 2 or 3. For more information
about the SNMP specification, see the SNMP RFCs. The SNMP agent sends traps through
TCP/IP to an external SNMP manager based on the SNMP configuration (the trap receiver
and other SNMP community parameters).
Format
show snmpcommunity
Mode
Privileged EXEC
Term Definition
SNMP
The community string to which this entry grants access. A valid entry is a case-sensitive
Community
alphanumeric string of up to 16 characters. Each row of this table must contain a unique
Name
community name.
Client IP
An IP address (or portion thereof) from which this device will accept SNMP packets with
Address
the associated community. The requesting entity's IP address is ANDed with the Subnet
Mask before being compared to the IP address. Note: If the Subnet Mask is set to
0.0.0.0, an IP address of 0.0.0.0 matches all IP addresses. The default value is 0.0.0.0.
Client IP Mask
A mask to be ANDed with the requesting entity's IP address before comparison with IP
address. If the result matches with IP address then the address is an authenticated IP
address. For example, if the IP address = 9.47.128.0 and the corresponding Subnet
Mask = 255.255.255.0 a range of incoming IP addresses would match, i.e. the incoming
IP address could equal 9.47.128.0 - 9.47.128.255. The default value is 0.0.0.0.
Access Mode
The access level for this community string.
Status
The status of this community access entry.

show snmptrap

Use this command to display SNMP trap receivers. Trap messages are sent across a
network to an SNMP Network Manager. These messages alert the manager to events
occurring within the switch or on the network. Six trap receivers are simultaneously
supported.
Format
show snmptrap
Mode
Privileged EXEC
Term Definition
SNMP Trap
The community string of the SNMP trap packet sent to the trap manager. The string is
Name
case sensitive and can be up to 16 alphanumeric characters.
IP Address
The IPv4 address to receive SNMP traps from this device.
IPv6 Address
The IPv6 address to receive SNMP traps from this device.
SNMP Version
SNMPv2
Status
The receiver's status (enabled or disabled).
The following shows an example of the CLI command.
ProSafe Managed Switch
Management Commands
670