Show Dot1Q-Tunnel; Show Dvlan-Tunnel - NETGEAR ProSafe M7100-24X User Manual

no mode dvlan-tunnel
This command is used to disable Double VLAN Tunneling on the specified interface. By
default, Double VLAN Tunneling is disabled.
Format
no mode dvlan-tunnel
Mode
Interface Config

show dot1q-tunnel

Use this command without the optional parameters to display all interfaces enabled for
Double VLAN Tunneling. Use the optional parameters to display detailed information about
Double VLAN Tunneling for the specified interface or all interfaces.
Format
show dot1q-tunnel [interface {<unit/slot/port> | all}]
Mode
• Privileged EXEC
• User EXEC
Term Definition
Interface
Valid slot and port number separated by forward slashes.
Mode
The administrative mode through which Double VLAN Tunneling can be enabled or
disabled. The default value for this field is disabled.
EtherType
A 2-byte hex EtherType to be used as the first 16 bits of the DVLAN tunnel. There are
three different EtherType tags. The first is 802.1Q, which represents the commonly used
value of 0x8100. The second is vMAN, which represents the commonly used value of
0x88A8. If EtherType is not one of these two values, then it is a custom tunnel value,
representing any value in the range of 0 to 65535.

show dvlan-tunnel

Use this command without the optional parameters to display all interfaces enabled for
Double VLAN Tunneling. Use the optional parameters to display detailed information about
Double VLAN Tunneling for the specified interface or all interfaces.
Format
show dvlan-tunnel [interface {<unit/slot/port> | all}]
Mode
• Privileged EXEC
• User EXEC
Term Definition
Interface
Valid slot and port number separated by forward slashes.
ProSafe Managed Switch
Switching Commands
61