Show Ip Vrrp Interface <Unit/Slot/Port; Open Shortest Path First (Ospf) Commands - NETGEAR GSM7328Sv1 - ProSafe 24+4 Gigabit Ethernet L3 Managed Stackable Switch Cli Reference Manual
Layer-3 stackable switches, software version 7.3
Hide thumbs
Also See for GSM7328Sv1 - ProSafe 24+4 Gigabit Ethernet L3 Managed Stackable Switch:
- Cli manual (787 pages) ,
- Hardware installation manual (42 pages) ,
- Administration manual (561 pages)
Table of Contents
Advertisement
Command Line Interface Reference for the ProSafe 7300S Series Layer-3 Stackable Switches,
14.4.12 show ip vrrp interface <unit/slot/port>
This command displays all configuration information and VRRP router statistics of a
virtual router configured on a specific interface.
Format
Modes
IP Address
VMAC address
Authentication
type
Priority
Advertisement
interval
Pre-Empt Mode
Administrative
Mode
State
14.5 Open Shortest Path First (OSPF) Commands
This section describes the commands you use to view and configure OSPF, which is a
link-state routing protocol that you use to route traffic within a network.
Note: The OSPF command is not available on the FSM7328S and FSM7352S
Routing Commands
show ip vrrp interface <unit/slot/port> <vrID>
Privileged EXEC
User EXEC
This field represents the configured IP Address for the Virtual
router.
Represents the VMAC address of the specified router.
Represents the authentication type for the specific virtual
router.
Represents the priority value for the specific virtual router.
Represents the advertisement interval for the specific virtual
router.
Is the preemption mode configured on the specified virtual
router.
Represents the status (Enable or Disable) of the specific
router.
Represents the state (Master/backup) of the virtual router.
switches.
v4.1, October 2008
14-25
Advertisement
Chapters
Table of Contents
