Ipv6 Management Commands; Network Ipv6 Enable - NETGEAR ProSafe M7100-24X User Manual

Term Description
IPv4 Multicast
The maximum number of IPv4 multicast forwarding table entries.
Routes
IPv6 Multicast
The maximum number of IPv6 multicast forwarding table entries.
Routes
Example:
#show sdm prefer
Current template: Dual IPv4 and IPv6
ARP Entries.................................... 4096
IPv4 Unicast Routes............................ 6112
IPv6 NDP Entries............................... 2048
IPv6 Unicast Routes............................ 3072
ECMP Next Hops................................. 4 I
Pv4 Multicast Routes........................... 256
IPv6 Multicast Routes.......................... 256

IPv6 Management Commands

IPv6 Management commands allow a device to be managed via an IPv6 address in a switch
or IPv4 routing (that is, independent from the IPv6 Routing package). For Routing/IPv6 builds
of Switch CLI dual IPv4/IPv6 operation over the service port is enabled. Switch CLI has
capabilities such as:
• Static assignment of IPv6 addresses and gateways for the network ports.
• The ability to ping an IPv6 link-local address over the network port.
• Using IPv6 Management commands, you can send SNMP traps and queries via the
network port.
• The user can manage a device via the network port (in addition to a routing interface).

network ipv6 enable

Use this command to enable IPv6 operation on the network port.
Default
enabled
Format
network ipv6 enable
Mode
Privileged EXEC
no network ipv6 enable
Use this command to disable IPv6 operation on the network port.
Format
no network ipv6 enable
Mode
Privileged EXEC
ProSafe Managed Switch
Management Commands
694