Port-Channel Linktrap; Port-Channel Load-Balance - NETGEAR ProSafe M7100-24X User Manual

port-channel linktrap

This command enables link trap notifications for the port-channel (LAG). The interface is a
logical unit/slot/port for a configured port-channel. The option all
notifications for all the
Default
enabled
Format
port-channel linktrap {<logical unit/slot/port> | all}
Mode
Global Config
no port-channel linktrap
This command disables link trap notifications for the port-channel (LAG). The interface is a
logical slot and port for a configured port-channel. The option all disables link trap
notifications for all the configured port-channels.
Format
no port-channel linktrap {<logical unit/slot/port> | all}
Mode
Global Config

port-channel load-balance

This command selects the load-balancing option used on a port-channel (LAG). Traffic is
balanced on a port-channel (LAG) by selecting one of the links in the channel over which to
transmit specific packets. The link is selected by creating a binary pattern from selected fields
in a packet, and associating that pattern with a particular link.
Load-balancing is not supported on every device. The range of options for load-balancing
can vary per device. The managed switch also supports enhanced hashing mode, which has
the following advantages:
• MODULO-N (where N is the number of active link members in a LAG) operation based on
the number of ports in the LAG
• Packet attributes selection based on the packet type: For L2 packets, source and
destination MAC address are used for hash computation. For L3 packets, source IP,
destination IP address, TCP/UDP ports are used.
• Non-Unicast traffic and unicast traffic is hashed using a common hash algorithm
• Excellent load balancing performance.
Default
3
Format
port-channel load-balance
{<unit/slot/port> |<all>}
Mode
Interface Config
Global Config
ProSafe Managed Switch
configured port-channels.
{ 1 | 2 | 3 | 4 | 5 | 6 | 7}
Switching Commands
115
enables link trap