Process Cpu Threshold; Show Process Cpu - NETGEAR ProSafe M7100-24X User Manual

The following information displays if you enter the count parameter:
Term Definition
Dynamic
Number of MAC addresses in the forwarding database that were automatically learned.
Address count
Static Address
Number of MAC addresses in the forwarding database that were manually entered by a
(User-defined)
user.
count
Total MAC
Number of MAC addresses currently in the forwarding database.
Addresses in
use
Total MAC
Number of MAC addresses the forwarding database can handle.
Addresses
available

process cpu threshold

Use this command to configure the CPU utilization thresholds. The Rising and Falling
thresholds are specified as a percentage of CPU resources. The utilization monitoring time
period can be configured from 5 seconds to 86400 seconds in multiples of 5 seconds. The
CPU utilization threshold configuration is saved across a switch reboot. Configuring the
falling utilization threshold is optional. If the falling CPU utilization parameters are not
configured, then they take the same value as the rising CPU utilization parameters.
Format
process cpu threshold type total rising <1-100> interval
<5-86400> {rising <1-100> interval <5-86400>}
Mode
Global Config
Parameter Description
rising threshold The percentage of CPU resources that, when exceeded for the configured rising interval,
triggers a notification. The range is 1 to 100. The default is 0 (disabled).
rising interval The duration of the CPU rising threshold violation, in seconds, that must be met to trigger a
notification. The range is 5 to 86400. The default is 0 (disabled).
falling threshold The percentage of CPU resources that, when usage falls below this level for the configured
interval, triggers a notification. The range is 1 to 100. The default is 0 (disabled). A notification
is triggered when the total CPU utilization falls below this level for a configured period of time.
The falling utilization threshold notification is made only if a rising threshold notification was
previously done. The falling utilization threshold must always be equal or less than the rising
threshold value. The CLI does not allow setting the falling threshold to be greater than the
rising threshold.
falling interval The duration of the CPU falling threshold, in seconds, that must be met to trigger a
notification. The range is 5 to 86400. The default is 0 (disabled).

show process cpu

This command provides the percentage utilization of the CPU by different tasks.
ProSafe Managed Switch
Utility Commands
523