Open Shortest Path First (Ospf) Commands; Show Ip Helper-Address; Router Ospf - NETGEAR GSM7328Sv1 - ProSafe 24+4 Gigabit Ethernet L3 Managed Stackable Switch Cli Manual

no ip helper-address discard
Use this command to permit the matching packets.
Format
no ip helper-address discard
{<1-65535>|dhcp|domain|isakmp|mobile-ip|nameserver|
netbios-dgm|netbios-ns|ntp|pim-auto-rip|rip|tacacs|tftp|time}
Mode Interface Config

show ip helper-address

Use this command to display the configured helper addresses on the given interface.
Format
show ip helper-address <interface>
Mode • Privileged EXEC
• User EXEC
The following shows example CLI display output for the command.
(switch) #show ip helper-address 1/0/1
Helper IP Address.............................. 1.2.3.4
............................................... 1.2.3.5

Open Shortest Path First (OSPF) Commands

This section describes the commands you use to view and configure OSPF, which is a link-state
routing protocol that you use to route traffic within a network.

router ospf

Use this command to enter Router OSPF mode.
Format
router ospf
Mode Global Config
Routing Commands
Managed Switch CLI Manual, Release 8.0
v1.0, July 2009
4-39