NETGEAR ProSafe M7100-24X User Manual page 588

The following parameters are displayed in the trace message:
Parameter Definition
TX/RX
TX refers to a packet transmitted by the device. RX refers to packets received by the
device.
Intf
The interface that the packet came in or went out on. Format used is unit/slot/port
(internal interface number).
SrcIp
The source IP address in the IP header of the packet.
DestIp
The destination IP address in the IP header of the packet.
AreaId
The area ID in the OSPF header of the packet.
Type
Could be one of the following:
HELLO – Hello packet
DB_DSCR – Database descriptor
LS_REQ – LS Request
LS_UPD – LS Update
LS_ACK – LS Acknowledge
The remaining fields in the trace are specific to the type of OSPF Packet.
HELLO packet field definitions:
Parameter Definition
Netmask
The netmask in the hello packet.
DesignRouter
Designated Router IP address.
Backup
Backup router IP address.
DB_DSCR packet field definitions:
Field Definition
MTU
MTU
Options
Options in the OSPF packet.
Flags
Could be one or more of the following:
• I – Init
• M – More
• MS – Master/Slave
Seq
Sequence Number of the DD packet.
ProSafe Managed Switch
Utility Commands
588