Config Router Rip Interface Version Send; Ospf Commands; Show Router Ospf Info - NETGEAR ProSafe GSM7312 User Manual

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
The value for <slot.port> is a valid routing slot and port number or all for selecting every routing
port.
The value for <mode> is one of: rip1 to receive only RIP version 1 formatted packets, rip2 for RIP
version 2, both to receive packets from either format, or none to not allow any RIP control packets
to be received.
Default
Format

config router rip interface version send

This command configures the interface to allow RIP control packets of the specified version to be
sent. The value for <slot.port> is a valid routing slot and port number or all for selecting every
routing port.
The value for <mode> is one of: rip1 to broadcast RIP version 1 formatted packets, rip1c (RIP
version 1 compatibility mode) which sends RIP version 2 formatted packets via broadcast, rip2 for
sending RIP version 2 using multicast, or none to not allow any RIP control packets to be sent.
Default
Format

OSPF Commands

show router ospf info

This command displays information relevant to the OSPF router. This command takes no options.
Format
Router ID
OSPF Admin Mode
ASBR Mode
The information below will only be displayed if OSPF is enabled.
ABR Status
8-14
both
config router rip interface version receive
<slot.port> <rip1|rip2|both|none>
rip1c
config router rip interface version send <slot.port>
<rip1|rip1c|rip2|none>
show router ospf info
A 32 bit integer in dotted decimal format identifying the router, about which
information is displayed. This is a configured value.
The administrative mode of OSPF in the router. This is a configured value.
Reflects whether the ASBR mode is enabled or disabled. Enable implies that the
router is an autonomous system border router. This is a configured value.
Reflects the whether or not the router is an OSPF Area Border Router.
202-10009-01
Routing Commands