Ip Multicast; Ip Multicast Ttl-Threshold - NETGEAR ProSafe M7100-24X User Manual

no ip mcast boundary
This command deletes an administrative scope multicast boundary specified by
<groupipaddr> and <mask> for which this multicast administrative boundary is applicable.
<groupipaddr> is a group IP address and <mask> is a group IP mask.
Format
no ip mcast boundary <groupipaddr> <mask>
Mode
Interface Config

ip multicast

This command sets the administrative mode of the IP multicast forwarder in the router to
active.
Default
disabled
Format
ip multicast
Mode
Global Config
no ip multicast
This command sets the administrative mode of the IP multicast forwarder in the router to
inactive.
Format
no ip multicast
Mode
Global Config

ip multicast ttl-threshold

This command is specific to IPv4. Use this command to apply the given Time-to-Live
threshold value <ttlthreshold> to a routing interface. The <ttlthreshold> is the TTL
threshold which is to be applied to the multicast Data packets which are to be forwarded from
the interface. This command sets the Time-to-Live threshold value such that any data
packets forwarded over the interface having TTL value below the configured value are
dropped. The value for <ttlthreshold> ranges from 0 to 255.
Default
1
Format
ip multicast ttl-threshold <ttlvalue>
Mode
Interface Config
ProSafe Managed Switch
IP Multicast Commands
318