Show Captive-Portal Configuration Status - NETGEAR ProSafe M7100-24X User Manual

If the interface is specified. The following term will be displayed.
Term Definition
Authenticated
The number of authenticated users associated with the CP ID.
users
Example
(Switch)#show captive-portal configuration 1 interface
CP ID..................................... 1
CP Name................................... cp1
Interface Interface Description
--------- ---------------------
Unit:1Slot:0Port:1
(Switch)#show captive-portal configuration 1 interface 1/0/1
CP ID..................................... 1
CP Name................................... cp1
Interface................................. 1/0/1
Interface Description..................... Unit: 1 Slot: 0 Port: 1 Gigab
Operational Status........................ Disabled
Disable Reason............................ Interface Not Attached
Block Status.............................. Not Blocked
Authenticated Users....................... 0

show captive-portal configuration status

Use this command to display information about all configured captive portal configurations or
about a specific captive portal configuration. The <1-10> is captive portal ID. If <1-10> is not
entered, all the configurations are displayed.
Format
show captive-portal configuration [ <1-10> ] status
Mode
Privileged EXEC mode
Term Definition
CP ID
The captive portal instance ID
CP Name
The captive portal instance name
Mode
The operational mode is enabled or disabled.
Protocol Mode
The protocol mode is https or http.
Verification Mode
The user verification mode has three modes: guest, local and radius. The default is
guest mode.
ProSafe Managed Switch
Operational
Status
----------------
Disabled Blocked
Captive Portal Commands
737
Block
Status
----------1/0/1