Show Ip Ospf Asbr; Show Ip Ospf Database - NETGEAR ProSafe M7100-24X User Manual

show ip ospf asbr

This command displays the internal OSPF routing table entries to Autonomous System
Boundary Routers (ASBR). This command takes no options.
Format
show ip ospf asbr
Mode
• Privileged EXEC
• User EXEC
Term Definition
Type
The type of the route to the destination. It can be one of the following values:
intra — Intra-area route
inter — Inter-area route
Router ID
Router ID of the destination.
Cost
Cost of using this route.
Area ID
The area ID of the area from which this route is learned.
Next Hop
Next hop toward the destination.
Next Hop Intf
The outgoing router interface to use when forwarding traffic to the next hop.

show ip ospf database

This command displays information about the link state database when OSPF is enabled. If
you do not enter any parameters, the command displays the LSA headers for all areas. Use
the optional <areaid> parameter to display database information about a specific area. Use
the optional parameters to specify the type of link state advertisements to display.
Parameter Description
asbr-summary
Use asbr-summary to show the autonomous system boundary router (ASBR) summary
LSAs.
external
Use external to display the external LSAs.
network
Use network to display the network LSAs.
nssa-external
Use nssa-external to display NSSA external LSAs.
opaque-area
Use opaque-area to display area opaque LSAs.
opaque-as
Use opaque-as to display AS opaque LSAs.
opaque-link
Use opaque-link to display link opaque LSAs.
router
Use router to display router LSAs.
summary
Use summary to show the LSA database summary information.
ProSafe Managed Switch
Routing Commands
289