Show Auto-Voip Interface - NETGEAR ProSafe M7100-24X User Manual

Note: The administrator has to enable tagging on auto-VoIP-enabled ports
to remark the voice data when it is egressed.
Format
auto-voip protocol-based {remark <remark-priority> | traffic-class
<tc>}
Mode
• Global Config
• Interface Config
Default
Traffic-class 7
no auto-voip protocol-based {remark | traffic-class}
This command is used to set the traffic-class to the default value.
Format
no auto-voip protocol-based {remark <remark- priority> |
traffic-class <tc>}
Mode
• Global Config
• Interface Config

show auto-voip interface

This command shows the configuration of the auto-voip per port.
Format
show auto-voip interface [oui-based|protocol-based]
{<unit/slot/port> | all}
Mode
• Privileged EXEC
• User EXEC
Example 1: If the configured auto-VoIP mode is protocol-based and the traffic-class is
configured.
Auto VoIP VLAN: 2
Interface Admin
Mode Mode
------------ ------------- ------------------- -------------
0/1 Enabled
Example 2: If the configured auto-VoIP mode is OUI-based.
Auto VoIP VLAN: 2
Auto VoIP OUI Priority: 7
Interface Admin
Mode Mode
------------ ------------- ------------
0/1 Enabled
ProSafe Managed Switch
Auto VoIP Traffic Class
protocol-based
Auto VoIP
oui-based
Quality of Service (QoS) Commands
489
7