Storm-Control Multicast Rate; Storm-Control Multicast Level (Global) - NETGEAR ProSafe M7100-24X User Manual

storm-control multicast rate

Use this command to configure the multicast storm recovery threshold for an interface in
packets per second. If the mode is enabled, multicast storm recovery is active, and if the rate
of L2 broadcast traffic ingressing on an interface increases beyond the configured threshold,
the traffic is dropped. Therefore, the rate of multicast traffic is limited to the configured
threshold.
Default
0
Format
storm-control multicast rate <0-14880000>
Mode
Interface Config
no storm-control multicast rate
This command sets the multicast storm recovery threshold to the default value for an
interface and disables multicast storm recovery.
Format
no storm-control multicast rate
Mode
Interface Config
storm-control multicast (Global)
This command enables multicast storm recovery mode for all interfaces. If the mode is
enabled, multicast storm recovery is active, and if the rate of L2 multicast traffic ingressing on
an interface increases beyond the configured threshold, the traffic will be dropped. Therefore,
the rate of multicast traffic will be limited to the configured threshold.
Default
disabled
Format
storm-control multicast
Mode
Global Config
no storm-control multicast
This command disables multicast storm recovery mode for all interfaces.
Format
no storm-control multicast
Mode
Global Config

storm-control multicast level (Global)

This command configures the multicast storm recovery threshold for all interfaces as a
percentage of link speed and enables multicast storm recovery mode. If the mode is enabled,
multicast storm recovery is active, and if the rate of L2 multicast traffic ingressing on an
ProSafe Managed Switch
Switching Commands
97