Network (Dhcp Pool Config) - NETGEAR ProSafe M7100-24X User Manual

host
This command specifies the IP address and network mask for a manual binding to a DHCP
client. Address and Mask are valid IP addresses; each made up of four decimal bytes ranging
from 0 to 255. IP address 0.0.0.0 is invalid. The prefix-length is an integer from 0 to 32.
Default
none
Format
host <address> [{<mask> | <prefix-length>}]
Mode
DHCP Pool Config
no host
This command removes the IP address of the DHCP client.
Format
no host
Mode
DHCP Pool Config
lease
This command configures the duration of the lease for an IP address that is assigned from a
DHCP server to a DHCP client. The overall lease time should be between 1-86400 minutes.
If you specify infinite, the lease is set for 60 days. You can also specify a lease duration.
Days is an integer from 0 to 59. Hours is an integer from 0 to 23. Minutes is an integer from
0 to 59.
Default
1 (day)
Format
lease [{<days> [<hours>] [<minutes>] | infinite}]
Mode
DHCP Pool Config
no lease
This command restores the default value of the lease time for DHCP Server.
Format
no lease
Mode
DHCP Pool Config

network (DHCP Pool Config)

Use this command to configure the subnet number and mask for a DHCP address pool on
the server. Network-number is a valid IP address, made up of four decimal bytes ranging
from 0 to 255. IP address 0.0.0.0 is invalid. Mask is the IP subnet mask for the specified
address pool. The prefix-length is an integer from 0 to 32.
Default
none
ProSafe Managed Switch
Utility Commands
560